3-3
3. Disassembly and Assembly
Description Photo Screws
8. Remove the connectors.
Caution : Servicing is not supported for the PCB.
▶Assembly
9. The assembly is in the reverse order of the
disassembly.
10. Connect the disassembled snap and the LED
module again.
11.Fixtheconnectingwirewithlamenttape
Caution : If the wire is damaged when closing the
cover, an operating error may occur.
Therefore, make sure to close the
coverafterxingitwithlamenttape.
lamenttape
To Next Page
Loading...
