Initial Setup
When you turn on your TV for the first time, it immediately starts the Initial Setup. During Initial Setup, connects to your
network, implements
Smart Hub
agreements, links to the source of your live TV signal, and sets up control of your cable or
set-top box.
To learn more about operating your TV, launch the TV's built in
e-Manual
after you have completed the Initial Setup. For
Information about the
e-Manual
, see "The
e-Manual
" on page 8.
Password Change
System
>
Change PIN
Changing the TV’s password.
1. Run
Change PIN
and then enter the current password in the password field. The default password is “0-0-0-0”.
2. Enter a new password and then enter it again to confirm it. The password change is complete.
- If you forgot your
PIN
code, press the buttons in the following sequence to reset the
PIN
to “0-0-0-0”:
In Standby mode: MUTE
→
8
→
2
→
4
→
POWER (On)
Using the TV Controller
You can use the TV Controller on the back of the TV instead of the remote control to control most of the functions of your TV.
Control Stick
The
Control Stick
is located
on the lower left corner of
the back of the TV.
Remote control sensor
Control Menu
: Opens
Smart Hub
.
: Opens the menu.
: Selects a source.
: Turns off the TV.
English - 4
[JU6400-ASIA]BN68-07235A-ENG.indb 4 2015-03-31 오전 9:59:52
To Next Page
Loading...
Need help?
General