4-1-2. No Video (Analog PC signal)
Symptom Audio is normal but no picture is displayed on the screen. -
Major
checkpoints
Check the PC source -
Check the Arsenal, Check the Valencia. -
Refer to the next page to check the lacation such a CN201 or IC201 SVC Manual mentioned. -
Diagnostics
Power indicator LED is off.
Lamp(Backlight) on, no video ?
Check the LVDS cable?
Replace the T-con / LCD panel?
Yes
Yes
Yes
Yes
No
No
Check a set in the ‘Stand-by mode’
or ‘DPMS mode’.
Please, Contact Tech support.
Input the analog PC signal properly.
Check the PC source and
check the connection of D-SUB ?
No
Check CN3011, PC cable.
Change the Main Assy.
Check IC7001.
Change the Main Assy.
No
No
Check the signal appear at input of IC6001 ?
PC_RED : C3059
PC_GREEN : C3060
PC_BLUE : C3061
PC_H_SYNC : C3251
PC_V_SYNC : C3250
Check the LVDS clk signal at output of
Main board? (TX1~TX4)
TX2_BP, TX2_CN, TX2_CP, TX2_CLKN
TX4_BP, TX4_CN, TX2_CP, TX2_CLKN
4
5
Caution Make sure to disconnect the power before working on the IP board.
To Next Page
Loading...
