• IR Blaster
Improved user convenience has been provided so that you can switch the channel and adjust the volume with just your fingertips while
focusing on the TV screen. In addition, the built-in Touch Pad removes the need for a mouse when you change the menu settings and
search for something on the Internet.
% For more detailed information about using the Smart Touch Control, refer to Smart Touch Control Guide (
‹
→
Support
→
Smart
Touch Control Guide).
% Voice Control performance levels will vary based on the language spoken.
Smart Touch Control / IR Blaster
Smart Touch Control
Installing batteries (Battery size: AA)
1
Press the back of the remote at the very bottom with both thumbs, and then
slide the battery cover up in the direction of the arrow.
2
Install two batteries so that the polarity of the batteries (+/-) matches the
illustration in the battery compartment.
3
Slide the cover down in the direction of the arrow to close the battery cover.
Connect the IR Blaster to the TV to control the external device with the Smart Touch Control.
If you set the Smart Touch Control to control the external device, the IR Blaster will send the IR Signal to an external device.
Install the IR Blaster within 50 cm and 45 degrees in up, down, left and right from the IR sensor of the external device.
Installing batteries (Battery size : AA)
IR Blaster
ൾઘࠫ
ಯீ
תீ
0/
0''
OPEN
OPEN
1"*3*/(
Device Indicator LED
IR Blaster shows the pairing
state.
Power Switch
Pairing Button
1
Hold the both sides of the battery holder and pull it out.
2
Install four batteries so that the polarity of the batteries (+/-)
matches the illustration in the battery compartment.
3
Push it back.
SMART TV
QUICK SETUP GUIDE
[Smart TV QSG-XN ZF]BN68-04471F-01L04.indb 1 2012-05-16 오전 11:37:24
To Next Page
Need help?
General
