04 Initial Setup
The initial setup dialogue box appears when the TV is first activated. Follow the on-screen instructions to finish the
initial setup process. You can manually perform this process at a later time in the > {§3 Settings > General > Start
Setup menu.
• If you connect any device to HDMI1 before starting the installation, the Channel Source will be changed to Set
top box automatically.
• If you do not want to select Set-top box, please select Aerial.
Using the TV Controller
Turn on the TV with the TV Controller button on the rear of the TV and then use the control menu. The Control menu
appears when the button is pressed while the TV is On. For more information about its usage, refer to the figure
below.
English - 12
To Next Page
Loading...
