4-2-5. No Video (Video 2-AV)
Symptom Audio is normal but no picture is displayed on the screen.
Major
checkpoints
Check the Video CVBS source.•
This may happen when the LVDS cable connecting the Main Board and the Panel is •
disconnected.
Diagnostics
Power indicator LED is off.
Lamp(Backlight) on, no video ?
No
Check a set in the ‘Stand-by mode’.
Yes
1
Check the video source and check the
connection of video cable?
No
Input the video source properly.
Yes
2
Check the LVDS signal at output of Main
Board ?
TX2_CLK : LV_TX2_DN/DP
TX4_CLK : LV_TX4_DN/DP
No
Check IC1001(X10+).
Change the Main Ass’y.
Yes
Check the LVDS cable?
Replace the T-CON, LCD panel?
No
Please, Contact Tech support.
Caution Make sure to disconnect the power before working on the IP board.
To Next Page
Loading...
