Samsung UN32C4000 - Install the Stand


01 Getting Started
English
Input Cables (Sold Separately)
HDMI HDMI-DVI Component Composite (AV) Coaxial (RF) VGA
Install the Stand
See separate guide for installing the stand.
s
s
s
s
s
Stand (1EA) Guide Stand (1EA) Screws (10EA)
Follow the steps below to connect the TV to the stand.
s
s
s
s
1
s
s
2
1. Connect the Guide Stand to the Stand
using four screws (M4 X L12) as shown.
2. With your TV upright,
connect the TV to the Stand
as shown.
3. Fasten three screws (M4 X
L8) at position , and then
fasten three screws (M4 X
L8) at position .
✎ NOTE
x
Make sure to distinguish between the front and back of the Stand and Guide Stand when assembling them.
x
Make sure that at least two persons lift and move the LED TV.
x
Stand the product up and fasten the screws. If you fasten the screws with the LED TV placed down, it may lean to
one side.
s
s
s
s
s
Top view
Rear
Guide Stand
Screws (M4 X L12)
Stand
(A)
(B)
5EA (M4 X L12)
5EA (M4 X L8)