Samsung UN32F5500AF - White Ratio (Balance) Adjustment

4-5. White Ratio (Balance) Adjustment
You can adjust the white ratio in factory mode (1:Calibration, 3:White-Balance).1.
Since the adjustment value and the data value vary depending on the input source, you have to adjust these in CVBS, 2.
Component 1 and HDMI 1 modes.
The optimal values for each mode are congured by default. It varies with Panel’s size and Specication.3.
Equipment : CS-210•
Pattern: MIK K-7256 #92 “Flat W/B Pattern" as standard•
Altenate Equipmet : CA200& anyone Master supported •
pattern#92(refer to right photo)
Use other Equipment only after comparing the result •
with that of the Master equipment.
Set Aging time : 60 min•
Calibration and Manual setting for WB adjustment
HDMI : Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (720p)•
COMP: Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (720p)•
CVBS: Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (NTSC)•
Note
If nishing in HDMI mode, adjustment coordinate is almost same in AV/COMP mode.
White Balance Manual adjustment
UN32F5500AF•
P-Mode
Input source
Section Adjustment Coordinate CA-210
HDMI
COMP
VIDEO
W/B High Hx 264 Hy 274 HY -
W/B Low Lx - Ly - LY -
MOVIE
W/B High Hx 318 Hy 340 HY -
W/B Low Lx - Ly - LY -
Sub Contrast 135 Sub Bright 128
R-Gain 128 G-Gain 128 B-Gain 128
R-Offset 128 G-Offset 128 B-Offset 128
4-43
4. Troubleshooting