◀ ▶
English
❑
Switching between Anynet+ Devices
1. Press the TOOLS button to select Anynet+ (HDMI-CEC). And then press the
ENTER
E
button to select Device List.
N
If you cannot find a device you want, select Refresh to refresh the list.
2. Select a device and press the ENTER
E
button. You can switch to the
selected device.
N
The Device List menu will only appear when you set Anynet+ (HDMI-CEC)
to On in the System menu.
●
Switching to the selected device may take up to 2 minutes. You cannot
cancel the operation during the switching operation.
●
If you have selected external input mode by pressing the SOURCE button,
you cannot use the Anynet+ function. Make sure to switch to an Anynet+
device by using the Device List.
To Next Page
Loading...
