English - 7
Reconnecting the Smart Touch Control
If the Smart Touch Control stops operating or works abnormally, replace the battery as this may be caused
by insufficient battery power. If the problem persists, press the PAIRING button on the Smart Touch Control
to restore pairing with the TV. The PAIRING button cannot be accessed without removing the Smart Touch
Control's battery cover. Within a distance between 1ft to 13.1ft(30cm to 4m), point the Smart Touch
Control to the TV receiver and press the PAIRING button. When pairing is complete, the pairing image
displays at the bottom left of the TV screen.
<The Smart Touch Control's pairing button>
Low Battery Power Warning
If the battery becomes low while using the Smart Touch Control, the following alarm window appears at the
bottom of the left screen. If the alarm window pops up, replace the batteries of the Smart Touch Control.
Use alkaline batteries for longer usage.
<Low battery alarm window>
[UF8000-ZC]BN68-04786B-08L02.indb 7 2013-10-28 �� 6:58:41
To Next Page
Loading...
