SMPS POWER
Power TV On.1.
PS_ON √ . 2Vdc (when off) changes to 3.3Vdc (on)
May already be On if IoT USB is loaded or TV Smart Things Hub mode is active. -
if voltage error or no change.2.
Jog Function Control Test. √
If OK replace Main Board.3.
All √ A13V supplies to full voltage level 12.7VDC.
If any wrong voltage, remove the SMPS connector to Main Board.4.
A13V again for 12.7VDC. √
If OK replace Main Board.5.
If still wrong voltage replace SMPS.6.
OD √ (Over Voltage Detect) : 3.3Vdc (Operating Normal)
If 0V or changing, an SMPS or Panel error exists.7.
Perform Backlight Test.8.
Backlight On/Off √ 0V Off to 5Vdc ON.
If missing/error replace √ Main Board.
49" / 55" SMPS Front
Fuse
CNM803
CNL801
CNM803
1 GND 2 GND 3 GND
4 GND 5 Vamp 6 GND
7 Vamp 8 OD_Level 9 Vamp
10 Fail Count 11 A13V 12 OD_ON/OFF
13 A13V 14 BLUEON/OFF 15 A13V
16 PS_ON/OFF 17 A13V 18 GND
19 GND 20 GND 21 PWM8
22 PWM7 23 PWM6 24 PWM5
25 PWM4 26 PWM3 27 GND
28 PWM2 29 PWM1 30 ANA_DIM
CNL801
1 IF2 2 IF1 3 1+ 4 5+
5 1- 6 5- 7 2+ 8 6+
9 2- 10 6- 11 3+ 12 7+
13 3- 14 7- 15 4+ 16 8+
17 4- 18 8-
To Next Page
Loading...
