Network Connection - Wired
There
are
two
main
ways
to connect your
TV
to
your
network
using
cable,
depending
on
your
network
setup
.
They
are
illustrated
below:
The
Modem
Port
on
the
Wall
Extternal
Modem
(ADSL
I
VDSL
I
Cable
TV)
Modem
Cable
(Not
Supplied)
The
LAN
Port
on
the
Wall
LAN
Cable
(Not
Supplied)
~A
network speed of lower
of
than
10
Mbps
is
not supported.
Configuring the Network Connection - Wired
1V
Rear
Panel
LAN
Cable
(Not
Supplied)
1V
Rear
Panel
Most
home
networks
use
the
Dynamic
Host
Configuration
Protocol
(DHCP)
to
configure
network connections.
Home
networks
that support
DHCP
automatically
provide
the
IP
address
, subnet
mask,
gateway,
and
DNS
values
your
1V
needs
to
access
the
Internet
so
you
don't
have
to
enter
them
manually.
To
configure your network connection for a network
that
uses
DHCP,
follow
these
steps:
1.
Connect your 1V
to
your
network
as
shown
in
one
of
the
illustrations
above.
2.
Turn
on
your
TV,
press
the
MENU button
on
your
remote,
and
then
select Network
----+
Network Settings.
The
Network Settings
screen
will
appear.
3.
Select
Wired,
press
ENTER
G.
and
then
press
ENTERGJ
again.
4.
The
Network Connection
screen
appears,
and
verifies
the
network
connection.
When
the
connection
has
been
verified,
the
"Internet
is
connected successfully."
message
appears.
Network
set
up
is
completed.
~
If
your
TV
cannot acquire network the connection
values
~
The
displayed
image
may
differ depending
on
the
model.
automatically
or
if
you
want
to
set
the connection
manually,
select IP Settings
on
the
network test
screen.
Set
Internet
Protocol Setup
to
Manual.
You
must enter the IP Address, Subnet Mask, Gateway,
and
DNS Server
manually.
~
For
more
detailed information,
see
"Wired
Network Connection"
in
the
e-Manual.
To Next Page
Loading...
