Samsung UN60D6450 - Network Connection Setup; Wireless Network Configuration

Wired/Wireless Network Connection
You can set up your TV so that it can access the Internet through your local area network (LAN) using a wired or wireless
connection.
Network Connection - Wireless
You can connect your TV to your LAN through a standard wireless router or modem.
The LAN Port on the Wall
Wireless IP Sharer
( AP having DHCP Server )
LAN Cable (Not Supplied)
)))
TV Rear Panel
Samsung's Wireless LAN adapter is sold separately and is offered by select retailers, Ecommerce sites and Samsungparts.
com. Samsung's Wireless LAN adapter supports the IEEE 802 . 11 a/big and n communication protocols. Samsung
recommends using IEEE 802.11 n. When you play video over a network connection, the video may not play smoothly .
Most
wireless network systems incorporate a security system that requires devices that access the network through an access
point or AP (typically a wireless IP Sharer- router or modem) to transmit an encrypted security code called an access key.
If you select Pure High-throughput (Greenfield) 802.11 n mode is selected and the Encryption type is set to WEP , TKIP or TKIP
AES (WPS2Mixed) on your AP or wireless router, Samsung TVs will not support a connection in compliance with new Wi-Fi
certification specifications .
Configuring the Network Connection - Wireless
The instructions below are for networks that use the Dynamic Host Configuration Protocol (DHCP) to configure network
connections
automatically. If your have a Static IP network, see your user's manual for configuration instructions.
To configure your network connection for a network that uses DHCP , follow these steps:
1. Connect your TV to your network as shown in the illustration above.
2. Turn on your TV, press the MENU button on your remote , and the
select Network - Network Settings.
3. Select the Wireless (General), press ENTER 1311 , and then press
ENTER 1311 again.
4. The Network function searches for available wireless network.
When done, it displays a list of the available networks.
5. In the list of networks , press the A or ~ button to select a
networks, select Next, and then press ENTER 1311 .
6. If you have selected a wireless router that has security, the
Security Key screen appears . Enter the Security key (Security
Key or PIN), select Next, and then press ENTER 1311 .
~ When you enter the Security Key (Security Key or PIN), use
The displayed image may differ depending on
the model.
the A I ~ I ~ I ~ buttons on your remote to select numbers and characters.
7. The Network Connection screen appears and verifies the network connection. When the connection has been verified, the
" Internet is connected successfully." message appears . Network set up is complete.
~ For more detailed information, see "Wireless Network Connection" in thee-Manual.