4-2-6. No Video (COMPONENT)
Note
Refer to the next page to check the location such a CN201 or IC201 SVC Manual mentioned.
Symptom Audio is normal but no picture is displayed on the screen.•
Major
checkpoints
Check the Component source•
This may happen when the LVDS cable connecting the Main Board and the Panel is •
disconnected.
Diagnostics
Power indicator LED is off.
Lamp(Backlight) on, no video ?
No
Check a set in the ‘Stand-by mode’.
Yes
Check the component source and check
the connection of component cables ?
Y, Pb, Pr
No
Input the component source properly.
Yes
1
Does the component data appear at ?
COMP2_Y_CVBS : R816 -
Pb : R817 -
Pr : R815 -
No
Check CN502.
Change the Main Ass’y.
Yes
2
Check the LVDS clk signal at output of
Main Board. (TX)
TX2_CLK : ODD_TXCLK_DN/DP -
TX4_CLK : EVEN_TXCLK_DN/DP -
No
Check IC1001(X12).
Change the Main Ass’y.
Yes
Check the LVDS cable?
Replace the T CON / LCD panel?
No
Please, Contact tech support.
Caution Make sure to disconnect the power before working on the IP Board.
To Next Page
Loading...
