troubleshooting _31
troubleshooting
CHECK THESE SOLUTIONS IF YOUR WASHER…
PROBLEM SOLUTION
Will not start. • Make sure the lid is closed.
• Make sure your washer is plugged in.
• Make sure the water source faucets are open.
• Make sure to press the Start/Pause button to start your Washer.
• Make sure Child Lock is not activated. See page 21.
• Before your washer starts to fill, it will make a series of clicking noises
to check the lid lock and do a quick drain.
• Check the fuse or reset the circuit breaker
Has no water or not enough
water.
• Turn both faucets on fully.
• Straighten the water inlet hoses.
• Disconnect hoses and clean the screens. Hose filter screens may be
clogged.
Has detergent remaining
in the automatic dispenser
after the wash cycle is
complete.
• Make sure your washer is running with sucient water pressure.
Vibrates or is too noisy. • Make sure your washer is set on a level surface. If the surface is not
level, adjust your washer’s feet to level the appliance.
• Make sure your washer is not touching any other object.
• Make sure the laundry load is balanced.
Stops • Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the lid and press the Start/Pause button to start your washer.
For your safety, your washer will not spin unless the lid is closed.
• Before your washer starts to fill, it will make a series of clicking noises
to check the lid lock and do a quick drain.
• There may be a pause or soak period in the cycle. Wait and it may
start.
• Check the screens on the inlet hoses at the faucets for obstructions.
Clean the screens periodically.
05 troubleshooting
F900A WASH_WA50F_USER MANUAL_DC68-03133H_EN.indd 31 2013-1-23 16:48:52
To Next Page
Loading...
Need help?
General