English 25
Installation
Installing the leg ring to the leveling feet (applicable models only)
A. Water drip pan
B. Bulge height less than 5/8”
• When using a water drip pan, install the
leg rings to the leveling feet to adjust
the height of the washer.
• You can nd the leg rings in the
accessory bag provided with the
product.
1. Slightly lift the washer, and then turn
the leveling feet (C) counterclockwise to
separate it from the washer.
2. Place the leg ring (D) to the leveling
feet.
Untitled-25 25 2020-03-02 PM 2:15:47
To Next Page
Loading...
