14-2
14. REFERENCE INFORMATION
14-2. REFERENCE INFORMATION
1) ASSY-MAIN PCB (Imbalance Sensor)
To prevent the laundry from gathering on one side of the tube causing noise and vibration, the washing machine uses an
imbalance detection device that evenly disentangles the laundry before the hydrating cycle starts.
2) DOOR-LOCK S/W
Prevents the door from being opened while a cycle is in progress. For safety purposes, it keeps the door locked even in
pause mode or after the washing cycle unless the water level frequency is greater than 23.5Khz (anti-overow level) or the
inside-tube temperature is less than65ºC in the hydrating cycle, and 55ºC in the washing cycle.
3) SENSOR-PRESSURE (Anti Over-Flow)
When the water supplied is more than 2/3 of the tube capacity due to a malfunction of the water supply valve, this device
automatically starts water-draining and displays “OVER-FLOW ERROR(OE)”on the LED.
4) THERMISTOR
Keeps sensoring and controlling the temperature inside the tube to keep it below your settings.
5) ASSY-THERMAL FUSE (Anti Over-Heat)
When the washing heater is overheated due to an error in the thermistor or any other malfunction, the assy-thermal fuse
(built in the heater) is automatically activated to disconnect the power for your and the product’s safety.
6) ASSY-MAIN PCB (Sensitive Laundry Protection)
To avoid any damage to sensitive laundry, the tube temperature is detected and “ERROR(CE)” is displayed on the LED for
Hand Wash or Delicate courses when the temperature is over 50.
7) THERMOSTAT (Anti Over-Heat)
When the heater (drier) overheats from an error in the thermistor or any other malfunction, the thermostat (installed on the
drying duct) is automatically activated to disconnect the power for your or product’s safety
8) CHILD LOCK
Prevents children from playing with the washing machine.
9) PRE-WASH
The machine does a preliminary wash of about 15 minutes prior to the main wash. This is particularly effective for cleaning
badly stained laundry.
To Next Page
Loading...
