2 _ Safety Instructions
WHILE SERVICING
• Check if the power plug and outlet are damaged, flattened, cut or otherwise degraded.
If faulty, replace it immediately.
Failing to do so may result in electric shock or fire.
• Completely remove any dust or foreign material from the housing, wiring and connection parts.
This will prevent a risk of fire due to tracking and shorts in advance.
• When connecting wires, make sure to connect them using the relevant connectors and check that they are
completely connected.
Do not use tape instead of the connectors, it may cause fire due to tracking.
• Make sure to discharge the PBA power terminals before starting the service.
Failing to do so may result in a high voltage electric shock.
• When replacing the heater, make sure to fasten the nut after ensuring that it is inserted into the bracket-heater.
If not inserted into the bracket-heater, it touches the drum and causes noise and electric leakage.
AFTER SERVICING
• Check the wiring.
Ensure that the wiring can not be damaged by any sharp edges or moving parts.
• Check for any water leakage.
Perform a test run for the washing machine using the standard course and check whether there is any water
leakage through the floor section or the pipes.
• Do not allow consumers to repair or service any part of the washing machine
themselves.
This may result in personal injury and shorten the product lifetime.
WARNING
WARNING
To Next Page
Loading...
