Out of Balance
When the unbalance time exceeds 15 minutes during the spin
cycle, it executes the untying operation to balance the load. It
will tumble at 50 RPM and add water and pump out twice, then
generate an error (dc) the third time. This will last about 30
minutes.
Temperatures under 60° may cause unit not to spin and
generate an error (dc)
See bulletin for software change on Main PCB - WF209ANW/XAA,
WF218ANB/XAA,
WF218ANW/XAA,WF219ANB/XAA,WF219ANW/XAA
Installation issues – Not leveled, Not locking the lock nuts,
Bending legs or frame when lifting, Shipping bolts in place,
Springs or struts broken or loose.
Installed on slippery floor without rubber foot pads.
Not properly locked on pedestal.
Questions or comments? Please e-mail richard.kuemin@marcone.com
To Next Page
Loading...
