Samsung WF56H9100A Series - Page 35

English _35
ERROR IMAGE MEANING & SOLUTION
tE1
A temperature sensor problem.
Restart the cycle. If the code reappears, call customer service.
3E
A motor problem.
Restart the cycle. If the code reappears, call customer service.
9E1/9E2
High/Low voltage detected.
Restart the cycle. If the code reappears, call customer service.
AE
A Communication error between the SUB(Sensor) PBA and the MAIN PBA
Call customer service.
8E
A MEMS sensor problem.
Call customer service.
SF1
SF2
SF3
A system error.
Call customer service.
SUd
Too many suds are detected during the wash session. The unit is put on hold
until the amount of suds have been reduced. When suds have been reduces, the
washer will re-start.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
05 troubleshooting
(USER)WF56H9100-03404A_EN.indd 35 2014-3-7 10:58:27