Samsung X10 Plus - Configuring the Password; Setting the Supervisor Password

6-4
SAMSUNG X10 Plus / X15 Plus / X30 Manual
Configuring the Password
O
Setting the Supervisor Password
By configuring a supervisor password, you can restrict system access to autho-
rized users only.
1. Select the Security menu in the System Setup. (To enter into System Setup, see
Page 6-2.)
2. On the ‘Set Supervisor Password’ item, press <Enter>.
3. Enter a password, press <Enter>, re-enter the password for confirmation, and
press <Enter> again.
4. When a message confirming the password configuration appears in the [Setup
Notice] window, press <Enter>.
Supervisor Password
controls access to the
setup utility.
Supervisor Password Is: Clear
User Password Is: Clear
HDD 0 Password Clear
Set Supervisor Password [Enter]
Set User Password [Enter]
Set HDD 0 Password [Enter]
Password on Boot [Disabled]
Fixed Disk Boot Sector [Normal]
Do not lose or forget your password. If you have forgotten your password,
contact the Samsung service center.
NN
NN
oo
oo
tt
tt
ee
ee