SAMWONTECH
1st Edition of TEMI2000_Series IM : Dec. 15. 2008 Page 45 / 58
7.16.3 How to WRITE program PATTERN
▶ Below describes process step to write programming PATTERN profile in TEMI2500.
① Write PATTERN number to program in D1701
② Write SEGMENT number to program in D1702
③ Write profile(TSP of temp.& humi. process time etc.)in D1725~D1733
④ Write WRITE TRIGGER('3') in D1707
⑤ Stay until reading D1708 response DONE('1')
Above process step ① ~ ⑤ is used to write ‘ONE SEGMENT’profile among all in programmed pattern.
Reiterate ① ~ ⑤ process step by changing segment number to write many segments.
To Next Page
Loading...
