Need help?Do you have a question about the Samwontech TEMP2500 and is the answer not in the manual?
General| Brand | Samwontech |
|---|---|
| Model | TEMP2500 |
| Category | Controller |
| Language | English |
Explains safety symbols and provides general remarks for safe manual usage.
Details the recommended and prohibited environments for installing the controller.
Illustrates the procedures for mounting the display unit onto a panel.
Describes VESA mount installation and DIN RAIL mounting for the control unit.
Covers general wiring precautions, cable/terminal specifications, and noise countermeasures.
Illustrates the terminal connections for the Display Units.
Provides instructions and diagrams for connecting the power source.
Explains wiring procedures for analog inputs (RTD, DCV, DCmA).
Details wiring for Voltage Pulse, Current, and Retransmission analog outputs.
Describes the System Parameter Set screen and its various parameter groups.
Details how to set up sensor inputs, including sensor type and range selection.
Describes the second sensor input screen and its associated parameters.
Explains piece bias setting and the calculation methods for compensation.
Details how to set control outputs and provides the first setup screen.
Covers retransmission output setup and the second screen for configuration.
Details the over-integral prevention function for controlling disturbances.
Covers output terminal display, settings, and the third setup screen.
Covers DO parameters and relay number settings for output.
Details the setup screens for inner and time signal relays.
Details how to set the communication interface method (RS-232C/RS-485).
Covers communication protocol and condition settings.
Explains how to set up Inner Signal application types, bands, and ranges.
Covers setting ON/OFF signal ranges, deviation, and delay times.
Details alarm operation settings and alarm type selections.
Covers setting PID ranges, reference points, and control modes.
Explains PID group settings including P, I, D values, and limits.
Covers DI display methods, buzzer time, and detection delay settings.
To Next Page
