Samwontech TEMI2000 Series - Page 19

SAMWONTECH
1st Edition of TEMI2000_Series IM : Dec. 15. 2008 Page 17 / 58
5.10 AMI Command
AMI Command is used to get the controller own-information.
▣ Request Message Frame
Bytes 1 2 3 2 1 1
Frame STX Address AMI SUM CR LF
▣ Response Message Frame
Bytes 1 2 3 1 2 1
Frame STX Address AMI , OK ,
9 2 7 2 1 1
Model Name SPACE Version-Revision SUM CR LF
◈ Exmaple
To confirm controller own information
- Request : [STX]01AMI[CR][LF]
- Response (with CheckSum) : [STX]01AMI38[CR][LF]
- Response : [STX]01AMI,OK,TEMI-2000[sp][sp]V00-R00[CR][LF]
- Response (with CheckSum) : [stx]01AMI,OK,TEMI-2000[sp][sp]V00-R001D[cr][lf]