Samwontech TEMI2000 Series - Page 39

SAMWONTECH
1st Edition of TEMI2000_Series IM : Dec. 15. 2008 Page 37 / 58
7.11 OUTPUT Group
This INPUT group is used for setting parameter D-Register for control output and retransmission.
█
OUTPUT setting D-Register
D-Reg. Symbol Descriptions
D1001 TEMP.OUT Temperature Control OUTPUT type
D1002 TEMP.DIR PID Control DIRECTION (FWD/REV) for temperature
D1003 TEMP.CT Pulse CYCLE TIME when‘SSR’temperature Control Output
D1004 TEMP.ARW ARW (Anti Reset Wind-up) function for temperature
D1005 TEMP.ATG Temperature Auto-Tuning GAIN value for Manual PID
D1008 HUMI.OUT Humidity Control OUTPUT type
D1009 HUMI.DIR PID Control DIRECTION (FWD/REV) for humidity
D1010 HUMI.CT Pulse CYCLE TIME when‘SSR’ humidity Control Output
D1011 HUMI.ARW ARW (Anti Reset Wind-up) function for humidity
D1012 HUMI.ATG Humidity Auto-Tuning GAIN value for Manual PID
D1015 TEMP.RETT Target TYPE of temperature retransmission
D1016 TEMP.RETH Range HIGH of temperature retransmission
D1017 TEMP.RETL Range LOW of temperature retransmission
D1020 HUMI.RETT Target TYPE of humidity retransmission
D1021 HUMI.RETH Range HIGH of humidity retransmission
D1022 HUMI.RETL Range LOW of humidity retransmission
D1025 RET.SEL Target object of retransmission.