SAMWONTECH
1th Edition of TEMP2000_Series IM : Dec. 15. 2008 Page 46 / 63
7.17.3 How to WRITE program PATTERN
▶ Below describes process step to write programming PATTERN profile in TEMP2500.
① Write PATTERN number to program in D2101
② Write SEGMENT number to program in D2102
③ Write profile(TSP of process time etc.)in D2126~D2141
④ Write WRITE TRIGGER('3') in D2107
⑤ Stay until reading D2108 response DONE('1')
Above process step ① ~ ⑤ is used to write ‘ONE SEGMENT’profile among all in programmed pattern.
Reiterate ① ~ ⑤ process step by changing segment number to write many segments.
To Next Page
Loading...
