Sanborn SB-WFT-16022 - User Manual

Questions and Answers

R
Ryan MontgomeryAug 15, 2025
Why does my Sanborn Trimmer engine smoke or run rough?
- M
  Melissa MooreAug 15, 2025
  If your Sanborn Trimmer experiences engine problems such as excessive smoke, rough running, erratic behavior, or inability to maintain full speed, consider these potential causes: 1. There may be no engine oil; add engine oil. 2. The engine oil level might be incorrect; check and adjust as necessary. 3. The spark plug could be fouled; inspect and replace if needed. 4. The air filter might be clogged; remove and clean it. 5. The fuel filter might be clogged; inspect and replace if needed. 6. The carburetor might be out of adjustment; take the unit to an authorized service center for adjustment. 7. The fuel might be contaminated; drain the tank, clean it, and refill with fresh fuel.
D
Dakota MitchellAug 20, 2025
Why is my Sanborn Trimmer trimming poorly?
- A
  andreawheelerAug 20, 2025
  If your Sanborn Trimmer is not trimming well, it might be due to the trimmer line being too short. Replace it with the correct length trimmer line (22 inches). Another reason may be that the engine is not at full throttle; move the throttle lever to the FAST position. Also, engine problems can cause poor trimming performance, so refer to engine solutions.
T
Tracy BradyAug 26, 2025
How to fix excessive vibration or noise in my Sanborn Trimmer?
- J
  Justin CannonAug 26, 2025
  Excessive vibration or noise in your Sanborn Trimmer can be caused by a few things. First, check for loose parts and tighten all fasteners. Second, ensure that the trimmer lines are of equal length; replace them if they are not. Third, see if the set screws in the trimmer head are loose; tighten them with a T-handle wrench. Finally, engine problems can cause excessive vibration or noise, so refer to engine solutions.
G
gonzalesbrittanyAug 30, 2025
What to do if the Sanborn SB-WFT-16022 head does not retain line?
- I
  iwilliamsAug 30, 2025
  If the trimmer head on your Sanborn Trimmer does not retain the line, it might be because the trimmer line is not properly attached. Follow the instructions in the maintenance section for attaching the line. It could also be due to a broken line retainer, in which case you should have the trimmer head assembly replaced. Make sure you are using the correct size trimmer line (0.155 in. / 4 mm). Finally, if the trimmer line is too brittle, use a trimmer line that has been soaking in water.
C
colemannicholasSep 4, 2025
What to do if my Sanborn SB-WFT-16022 Trimmer engine will not stop?
- N
  Nicholas CraigSep 4, 2025
  If the engine of your Sanborn Trimmer will not stop, inspect the throttle control lever and wire. Replace them if necessary.
R
Robert BautistaNov 9, 2025
Why is my Sanborn SB-WFT-16022 Trimmer engine difficult to start?
- G
  Gregory DoughertyNov 9, 2025
  If the Sanborn Trimmer engine is difficult to start, there are several potential causes: * It might be out of fuel, in which case you should add fresh fuel. * The throttle might be in the Stop position; move it to the Start position. * The engine might not be primed; press the Primer bulb 3 times, waiting 2 seconds between each push. * The engine could be flooded; wait a few minutes before attempting to start it again. * The spark plug wire might be disconnected; attach it to the spark plug. * The throttle control lever or wire might be defective; inspect and replace if necessary. * The spark plug could be fouled; remove, inspect, and replace if needed. * The air filter might be clogged; remove and clean it. * The fuel filter might be clogged; remove, inspect, and replac...

Sanborn SB-WFT-16022 Specifications

General

Brand	Sanborn
Model	SB-WFT-16022
Category	Trimmer
Language	English

Sanborn SB-WFT-16022 - User Manual

Table of Contents

Questions and Answers

Sanborn SB-WFT-16022 Specifications