V21 Parts & Service Manual
All V21 Identified Equipment
REV A – 10/2013
P/N: 1230336
READING A PARTS LIST
I. ITEM NUMBER is found in two locations:
A. It is on the drawing plate, and identifies the part and its location;
B. The same number is in the parts lists and ties the two together.
II. PART NUMBER is the part number that has been assigned to a specific part by
SandenVendo America, Inc., for easier identification.
III. QUANTITY REQUIRED relates to the amount required of a part, or will be indicated by
“A/R” (as required) to attach it to another part.
IV. PART NAME AND DESCRIPTION is the general description for the part, for easier
identification when ordering a like part.
V. HARDWARE is identified by a letter in a hexagon. Refer to hardware list section or
description and part numbers. See pages C-3 and C-4.
The example below will show how the parts are listed in the parts lists:
1. VEND MOTOR ASSEMBLY: This is the main assembly name, and any replaceable parts
will be indented below the assembly.
2. RETAINER CAM: This is an individual part, and will be indented. These indented parts
can be ordered separately, so you do not need to order the entire assembly.
3. Whenever an assembly is ordered, all the parts that are indented will be included in the
assembly. Any hardware will be listed next to their corresponding parts.
4. Any parts that may be ordered separately will not have any indented parts listed below
them.
If an asterisk is listed below the parts list, it is an indication that special information is noted.
There may be more than one asterisk (*) (**) (***) denoting special notes.
V21 Cabinet Parts | C-2
To Next Page
Loading...
