V21 Parts & Service Manual
All V21 Identified Equipment
REV A – 10/2013
P/N: 1230263
Set Price:
This Mode allows you the option to price each selection to the same vend price, or price each
selection button independently.
1. When display reads “Set Price” press Button 4.
2. Press Button 2 or 3 to choose selections or “All.”
3. Press Button 4 to start the current vend price flashing.
4. Press Button 2 or 3 to increase or decrease price.
5. Press Button 4 to save your new programmed price.
6. Press Button 1 to exit mode.
Correct Change Only:
This mode allows you to manipulate the credit acceptance and customer display messages for use
of correct change.
Customer Overpay:
On- Money will be accepted when the “Use Exact Change” display is on and there is
insufficient coins in the coin tubes.
Off – Exact or sufficient change required to make a vend.
Correct Change:
This is the minimum amount of change needed in the coin mechanism before the controller
displays the “Use Exact Change” message.
Accept Value:
This is the largest denomination of any single form of currency that can be accepted without
the knowledge that the equivalent value of coins can be returned.
Set Depth:
This Mode allows you to set the depth of each column. In this mode, you have the option of
setting the columns for single, double, triple or quadruple depths.
1. When display reads “Set Depth” Press Button 4.
2. Press Button 2 or 3 to choose columns or “All.”
3. Press Button 4 to enter into the column and start the depth flashing.
4. Press Button 2 or 3 to scroll through the depth settings (1-4).
5. Press Button 4 to save your new depth setting.
6. Press Button 1 to exit mode.
Configuration:
This mode allows you to set the different configurations in the vendor.
Default options are underlined
Multi-Price
On - All selections can be programmed individually.
Off - All selections will be set to the same price as Selection 1.
V21 12.4 Programming Coke Chameleon | P2-7
To Next Page
Loading...
