SandenVendo V21 621 - Page 60

V21 Parts & Service Manual
All V21 Identified Equipment
REV A – 10/2013
P/N: 1230263
Refrigeration: * Features on version 14 and above.
If ‘Timing Features’ in Configuration Mode are ‘Off’, you will only have access to the following
features:
Set Point Temperature: The cabinet temperature during the normal mode. Refrigeration cuts-in
two degrees above and cuts-off at a degree below the set point.
* Storage Temp: 45- Thisis the storage temperature during the energy saving mode.
* Display Temp. Off / On – The option to display the cabinet temperature in the display.
* Defrost Interval: 6h (1 –24 hrs) –The interval time for the compressor to perform a defrost
cycle routine.
* InActivity Time: 35m – Time for the refrigeration system to go into energy savings mode after
no sales activity – This is applicable if the Enable is set to “2”.
Sensor Reading:– Refrigeration Temperature reading inside the cabinet.
Degree Setting:– Can change the temperature to Celsius or Fahrenheit.
Fan Energy Mode: – Mode 0 – The fan turns off on door open and turns on door close
Mode 1 – The fan turns off 5 minutes after the compressor stops and starts
when the compressor turns on
Default - The fan is turned on all the time.
Please note that the fan mode 1 and mode 2 is optional and needs a special hardware.
Periodic Defrost Mode:– Enables the refrigeration system to perform periodic defrost cycle.
Enable0 – Disabled – Refrigeration is regulated based on set point..
1 – Refrigeration can be regulated at timed intervals.
2 – Refrigeration is regulated based on Sales Activity. Refer to Energy Management
System Section.
To change the set point temperature:
1. Press Button 4 when the display reads “Refrigeration.”
2. The display will read “Set Point XX” with the current setting displayed.
3. To change the setting press Button 4 and the current set point temperature will begin to
flash.
4. Press Button 2 or 3 to increase or decrease the set point.
5. Press Button 4 to save changes.
6. Press Button 1 to exist and return “Refrigeration” on display.
* To change the storage temperature:
1. Press Button 4 when the display reads “Storage Temp.”
2. The display will read “Storage Temp. 45” with the current setting displayed.
3. To change the setting press Button 4 and the current storage temperature will begin to
flash.
4. Press Button 2 or 3 to increase or decrease the storage temperature.
5. Press Button 4 to save changes.
6. Press Button 1 to exit
V21 12.4 Programming Coke Chameleon | P2-12