V21 Parts & Service Manual
All V21 Identified Equipment
REV A – 10/2013
P/N: 1230298
If selection button two is pressed at the “dSCn” prompt, the controller will enter the
Discounting Over-Ride Enable Option. Upon entry into this program the display will show the
current setting “
dSC4” for enable and “dSCn” for disable. Pressing selection button one will
toggle between “y” for enabled and “n” for disable. Pressing selection button three will save the
currently displayed setting and return the operator to the “
dSCn” prompt.
“Y” = Enable discount over-ride.
“N” = Disable discount over-ride.
V21
12.1 Programming Trade | P3-17
To Next Page
Loading...
