SandenVendo V21 621 - Page 95

V21 Parts & Service Manual
All V21 Identified Equipment
REV A – 10/2013
P/N: 1230328
• Press (2) at the “Set Clock” prompt. You will be able to scroll through the following
options by pressing (1).
o “Enable ON/OFF” - This will turn the clock timer on or off.
o “MM/DD/YYYY HH:MM” - This is the current time and date.
o “Daylight Savings”
• To change current setting, press (2).
• The current setting will begin to flash.
• Press (1) to change current setting.
• Press (2) to save current setting.
Lighting:
If the “Timing Features” in the “Configuration” mode are turned ON, you will have access to this
mode. This mode allows you to turn the lights on/off with the internal timer.
• Press (2) when the display reads “Start Time 1” or “Start Time 2.”
• Press (2) at “Start Time 1” or “Start Time 2.”
• Press (2) at “Start Day 1” or “Start Day 2.”
• Scroll through the days of the week or “all” with (1).
• To change current setting, press (2).
• Change setting with (1).
• Save changes with (2).
• Press (1) at “Start 100.00” or “Start 200.00”
• Press (2) to change time.
• Press (1) to set time.
• Press (2) to save.
• Press (3) to exit mode.
• Repeat process with “Stop Time 1” or “Stop Time 2.”
Refrigeration:
If ‘Timing Features’ in Configuration Mode are ‘Off’, you will only have access to the following
modes:
Set Point Temperature
Sensor Reading
Degree Setting
Fan Energy Mode
Periodic Defrost Mode
To change the set point temperature:
• Press (2) when the display reads “Refrigeration.”
• The display will read “Set Point XX” with the current setting displayed.
V21 12.3
Programming HVV | P4-9