SanDisk CompactFlash Extreme III User Manual

CIS Description SanDisk CompactFlash Card OEM Product Manual
Table 6-1 Card Information Structure
Attribute
Offset Data 7 6 5 4 3 2 1 0 Content Description
CIS
Function
0BEh C1h I
1
D
1
Configuration Index
1
I/O Mapped Contiguous
16 Registers
Configuration.
TPCE_INDX
Configuration Index for
this entry is 1. Interface
Byte follows this byte.
Default Configuration,
therefore is not
dependent on previous
Default Configuration.
D: Default Configuration
I: Interface Byte follows
0C0h 41h W
0
R
1
P
0
B
0
Interface Type
1
I/O Interface(1), Bvd's
and wProt not used;
Ready/-Busy active but
Wait not used for
TPCE_IF
memory cycles.
B: Battery Volt
Detects Used
P: Write Protect Used
R: Ready/-Busy Used
W: Wait Used for
Memory Cycles
0C2h 99h M MS IR IO T P V
CC
Only Power
TPCE_FS
1 0 1 1 0 1
Descriptors; No Timing;
I/O and IRQ present; No
Memory Space; Misc
Entry Present
P: Power Info type
T: Timing Info present
IO :I/O Port Info present
IR: Interrupt Info present
MS: Memory Space Info
type
M: Misc Info Byte(s)
present
0C4h 27h R DI PI AI SI HV LV NV Nominal Voltage Follows
Power
0 0 1 0 0 1 1 1 NV: Nominal Voltage
LV: Mimimum Voltage
Parameters
for V
CC
HB: Maximum Voltage
SI: Static Current
AI: Average Current
PI: Peak Current
DI: Power Down Current
0C6h 55h X Mantissa Exponent V
CC
Nominal is 5V V
CC
Nominal
0 Ah = 5.0 5h = 1V
Value
02/07, Rev. 12.0 6-8 © 2007 SanDisk Corporation

SanDisk CompactFlash Extreme III Specifications

General

Brand	SanDisk
Model	CompactFlash Extreme III
Category	Camera Accessories
Language	English