S&P EMIDRY-D User Manual

17
8. MANUAL OPERATION
8.1 Connecting the appliance
Set the ON/OFF switch located on the rear of the control panel to ON (with the
red part showing).Once the appliance is ON, the display shows the ambient
temperature. The blobs and pilots shown on the display may differ.
8.2 Function select
If the ON indicator on the display is not lit up, the appliance is in STOP. Press
the central
key to set the mode . The display shows the ambient
temperature in subdued light, and a blob lights up in the lower right corner of
the display to indicate the appliance is ON. If the temperature setting is higher
than the ambient temperature, the appliance will start heating up.
Press the
key again and the heater enters mode . The blue pilot lights up to
indicate this. The appliance will heat up if the temperature setting is at least
3.5ºC higher than the ambient temperature.
Press and hold the central
button for 2 seconds to put the appliance in
standby mode. The ON indicators disappears from the display (steady blob in
the lower right corner) and the appliance continues to display the ambient
temperature.
8.3 Temperature select
To set the desired temperature, press the or keys. The display lights up
fully and with each successive press on the
or keys the temperature
setting increases or decreases by 1Cº. Once 5 seconds have elapsed with no
further keys pressed the display returns to subdued lighting mode and once
again shows the ambient temperature.
8.4 Anti-freeze function
Press the "minus" key until the lower threshold value is reached. The display
shows AF (anti-freeze) as shown below:
When this function is activated, the appliance switches on when the ambient
temperature falls to 5ºC, keeping the temperature at between 5ºC and 6ºC.
A
lwa
y
s
Where it
corresponds

S&P EMIDRY-D Specifications

General

Brand	S&P
Model	EMIDRY-D
Category	Heater
Language	English