S&S SH Series - Warranty

DISCLAIMER:
S&S parts are designed for high performance, closed course, racing applications
and are intended for the very experienced rider only. The installation of S&S parts
may void or adversely eect your factory warranty. In addition such installation and
use may violate certain federal, state, and local laws, rules and ordinances as well
as other laws when used on motor vehicles used on public highways, especially in
states where pollution laws may apply. Always check federal, state, and local laws
before modifying your motorcycle. It is the sole and exclusive responsibility of the
user to determine the suitability of the product for his or her use, and the user shall
assume all legal, personal injury risk and liability and all other obligations, duties,
and risks associated therewith.
The words Harley®, Harley-Davidson®, H-D®, Sportster®, Evolution®, and all H-D
part numbers and model designations are used in reference only. S&S Cycle is not
associated with Harley-Davidson, Inc.
SAFE INSTALLATION AND OPERATION RULES:
Before installing your new S&S part it is your responsibility to read and follow the
installation and maintenance procedures in these instructions and follow the basic
rules below for your personal safety.
• Gasoline is extremely ammable and explosive under certain conditions and
toxic when breathed. Do not smoke. Perform installation in a well ventilated
area away from open ames or sparks.
• If motorcycle has been running, wait until engine and exhaust pipes have
cooled down to avoid getting burned before performing any installation steps.
• Before performing any installation steps disconnect battery to eliminate
potential sparks and inadvertent engagement of starter while working on
electrical components.
• Read instructions thoroughly and carefully so all procedures are completely
understood before performing any installation steps. Contact S&S with any
questions you may have if any steps are unclear or any abnormalities occur
during installation or operation of motorcycle with a S&S part on it.
• Consult an appropriate service manual for your motorcycle for correct
disassembly and reassembly procedures for any parts that need to be removed
to facilitate installation.
• Use good judgment when performing installation and operating motorcycle.
Good judgment begins with a clear head. Don’t let alcohol, drugs or fatigue
impair your judgment. Start installation when you are fresh.
• Be sure all federal, state and local laws are obeyed with the installation.
• For optimum performance and safety and to minimize potential damage to
carb or other components, use all mounting hardware that is provided and
follow all installation instructions.
Motorcycle exhaust fumes are toxic and poisonous and must not be breathed. Run
motorcycle in a well ventilated area where fumes can dissipate.
WARRANTY:
All S&S parts are guaranteed to the original purchaser to be free of manufacturing
defects in materials and workmanship for a period of twelve (12) months from the
date of purchase. Merchandise that fails to conform to these conditions will be
repaired or replaced at S&S’s option if the parts are returned to us by the purchaser
within the 12 month warranty period or within 10 days thereafter.
In the event warranty service is required, the original purchaser must call or write
S&S immediately with the problem. Some problems can be rectied by a telephone
call and need no further course of action.
A part that is suspect of being defective must not be replaced by a Dealer without
prior authorization from S&S. If it is deemed necessary for S&S to make an evaluation
to determine whether the part was defective, a return authorization number must
be obtained from S&S. The parts must be packaged properly so as to not cause
further damage and be returned prepaid to S&S with a copy of the original invoice
of purchase and a detailed letter outlining the nature of the problem, how the part
was used and the circumstances at the time of failure. If after an evaluation has been
made by S&S and the part was found to be defective, repair, replacement, or refund
will be granted.