Powersaver Dual Flexi
Immersion Water Heater Controller
Installation Instructions
SERVICE AND WARRANTY
Guarantee: as shown on product identication label.
Any tampering or misuse will invalidate this guarantee.
This product must meet Waste Electronic and
Electrical Equipment Regulations (WEEE) for suitable
environmental recycling, recovery and/or disposal.
End of life products should be handled in line with local
regulations. Alternatively return end of life product to
Sangamo for correct disposal.
CUSTOMER CARE POLICY
As part of Sangamo’s continuous improvement
program, the company operates a Customer Care
policy. This means we welcome your comments and
complaints, as it can help us to improve our services
to you, our customer.
Due to our policy of continuous product improvement
and development, the specications in this guide may
be subject to change without prior notice.
Sangamo Limited
Industrial Estate, Port Glasgow,
Renfrewshire, PA14 5XG
Tel 01475 745131
Fax: 01475 600370
Email: enquiries@sangamo.co.uk
Web: www.sangamo.co.uk
WEE/JH0069TY
143884 A
Rating 13A, 230V, 50Hz,
suitable for immersion heaters up to 3kW
Live parts Enclosed
Dirt protection IP30
Shock protection Class 1
Contacts Micro Disconnection
Temperature 0 - 35°C
Battery reserve Approx. 10 years, Non-rechargeable, Lithium
Clock accuracy +/- 6mins per year @23°C
Dimensions H:114mm W:169mm D:61mm
Program cycle 24 hour
Summer/Winter time change Automatic
O peak program Installer selectable - 10 adjustable presets available
covering low rate electricity tarrifs; Economy 7,
Economy 10 & Eco20:20
Boost facility User selectable - ½, 1 or 2 hours
Boost program User selectable - up to hours
SPECIFICATIONS
This unit must be installed by a suitably qualied person in accordance with the
latest IEE Wiring Regulations.
Isolate mains supply before commencing installation. Please read all installation
instructions before proceeding.
Provision must be made in the xed wiring for a means of disconnection from the supply
having a contact separation of at least 3mm on all poles. This can be provided by the
consumer unit.
The Powersaver Dual Flexi is supplied with its own mounting box, which can be mounted
over a single or double gang flush wall box.
This product is not suitable for mounting on unearthed metal or metalised surfaces.
SAFETY NOTICE
!
Single Immersion Heater Dual Immersion Heater Two Immersion Heater
To Next Page
Need help?
General