Sangean PR-D1 - Station Memory Management; Storing and Recalling Stations; Preset Station Exchange

6
12
13
12
13
The tuning increments are :
FM :50 kHz
MW: 9 kHz
LW : 1 kHz
Storing stations (Memory)
For each of the 3 wave bands, 9 transmitting stations can be stored via
MEMO button and PRESET + - button . A total 27 presets can be used.
Tune in the desired station as described above, then press MEMO button
for memory, display will show SAVE M1 to suggest you to store the
station on PRESET 1 (you may select your PRESET No. by using PRESET + -
button ) then press MEMO button again, display memory slots will show
preset No. with block indicating the station being stored.
If all the 9 presets being stored already, display will show FULL, in
this case if you still requite to store the station, press MEMO button
again, display will show SAVE-->M9(again you may select your PRESET
no. by using PRESET + - button), then press MEMO button again, the previous
PRESET station will be deleted and replace with the new station.
PRESET (Memory) exchange
You may exchange the PRESET for your own editing purpose.
First, recall the station, and press MEMO button, then PRESET + -
button to the required new preset, then press MEMO button again.
The preset stations will be then exchanged.
For example, if you like to exchange PRESET 3 and PRESET 6, recall PRESET
3, press MEMO and PRESET + - to the desired 6 (Display will show SAVE-->M6)
then press MEMO button again. Then PRESET 3 becomes PRESET 6 and PRESET 6
becomes PRESET 3.
If you like to exchange PRESET 3 to blank preset position 9, recall PRESET
3, press MEMO and PRESET + - to the 9 (Display will show SAVE-->M9)then
press MEMO button again. Then PRESET 3 become PRESET 9 and PRESET 3 become
blank.