Sanjian Studio PLJ-0802-A - Measurement Connections; Hard-Wired Measurement Method; Inductive Sensing Measurement Method

1.
Hard Wired:
Connect Test Meter to the signal measurement point with an appropriate test cable.
Direct connection to Transmitter antenna port requires impeadence matching &
may require the use of attenuator(s). Excessive signal will damage meter.
2. Sensing Method
Connect Test Meter using inductive coupling to the transmitter under test.
Due to the high impedance input of meter; High power Radio frequency
transmitting devices may require the use of attenuator(s).
Strong radation fields may require meter shielding and moving meter away from
source as well as attenuator(s).
NOTE: Signal level < 50mV RMS may cause unstable readings.)
page 7
5. Meausurment Connection
36536-TE