14
2
3
1
• Inserting bobbin
1 Place a bobbin in the bobbin case, making
sure the thread feeds clockwise from the
bobbin.
2
Draw the thread through the slot of the case.
3
Continue to draw the thread under the
tension spring and through the opening.
Pull out about 4˝ (10 cm) of thread.
Tension spring
4
Holding the latch open, position the bobbin
case into the shuttle, and then release the
latch.
The case should lock into the place when the
latch is released.
4
1
1
To Next Page
Loading...
