16
1
2
3
4
5
1
3
2
5
4
Threading the Machine
• Threading the machine
* Place a spool on the spool pin, with thread
coming off as shown.
* Raise the thread take-up lever to its highest
position by turning the handwheel counter-
clockwise.
* Raise the presser foot.
Draw the end of thread around the thread
guide.
Thread guide
Slide the thread behind the needle bar thread
guide on the left.
Needle bar thread guide
Thread the needle from front to back.
Firmly draw the thread up along the left
channel. Slip the thread into the slit of the
thread take-up lever from right to left and
down into the take-up lever eye.
5
4
3
While holding the thread near the spool, draw
the end of the thread down along the right
channel and around the bottom of the guide
plate.
2
1
1
2
1
2
To Next Page
Loading...
