Sansui A-X950 - User Manual

SERVICE MANUAL
SI SANSUI |
&/SANSUI
ee EL Li
/\
S
5
|
T
os
MINI COMPONENT SYSTEM
<INTEGRATED AV SURROUND AMPLIFIER>
Organization of System Component
System Name Amplifier Tuner CD Player Cassette Deck Speaker
MC-X950/X950L A-X950 T-X950/X950L. CD-X950 D-X950 S-X950
CAUTION
1. Parts identified by the 4\ symbol on the schematic diagram and the parts list are critical for safety.
Use only replacement parts that have critical characteristics recommended by the manufacturer.
2.
Make
leakage-current
or
resistance
measurements
to
determine
that
exposed
parts
are
acceptably
insulated
from
the
supply
circuit
before
returning
the appliance
to
the
customer.
NOTICE
Abbreviations
List
1. Some printed circuit boards are not supplied assembied. CR. : Carbon Resistor E.B.L : Low Leak Bi-Polar
To separate these in this service manual, the stock numbers are S.R. : Solid Resistor Electrolytic Capacitor
not
indicated
for
these
boards.
However,
stock
numbers
for
Ce.R.
—:
Cement
Resistor
Ta.c.
:
Tantalum
Capacitor
individual
parts
are
indicated.
M.R.
:
Metal
Film
Resistor
F.C.
:
Film
Capacitor
2.
The
symbols,
EU,
EG,
IPT,
SS
and
XX
<EXPORT>
on
the
parts
F.R.
:
Fusing
Resistor
M.P.
:
Metalized
Paper
list and the schematic diagram mean followings respectively. N.ILR. —: Non-Inflammable Capacitor
BU cicsiscsstenccsssass Manufactured for European market. Resistor — P.C. : Polystyrene
EG .. Manufactured for F.R. Germany market. AR. : Array Resistor — Capacitor
IPT
..
Manufactured
for
Italy
market.
C.C.
:
Ceramic
Capacitor
M.M.C.
:
Metalized
Mylar
SS... ..Manufactured for Saudi Arabian market. C.T. —_: Ceramic Capacitor, Capacitor
7
Temperature
A.C.
:
Array
Capacitor
XX cersessseveeesnseee Standard Version. C ; hagas ;
<EXPORTS
2,
roe.
ao
NON MARK ....Common Parts. Semmes Dalal leo pests Se emieS lt lc
H 7 A itted f list E.L. : Low Leak Electrolytic Resistor
3. Since some capacitors and resistors are omitted from parts lists Capacitor Sw. : Switch
in this service manual, refer to the Common Parts List for
capacitors and resistors, which was issued on June 1987.
4. Abbreviations in this Parts List are as follows.
E.B. : Bi-Polar Electrolytic Chip R. : Chip Resistor
Capacitor i : Chip Capacitor
Specifications
Power
output
(Front
channel)
Frequency
response
(at
1
watt)
Min. RMS, both channels driven, from 20 to 20,000 Hz, with no BS, LD, VCR........sccscsscssssssoeeeeees .10 to 50,000 Hz, +1 dB, -3 dB
more than 0.7% total harmonic distortion. 40 watts per channel BASS PREOUT .....scsssssecseessseseens 10 to 200 Hz, +1 dB, -3 dB
into 6 ohms. .
beter output (Center channel) Signal to noise ratio (short-circuit, A-network)
Min. RMS, both channels driven, at 1 kHz, with no more than BS, LD, VCR uo. essscscessseeeetseeseeees 90 dB
1% total harmonic distortion. 12 watts per channel into 6 TONE CONTROL
ohms. + 12 dB (250Hz)
Power output (Rear channel) + 12 dB (1 kHz)
Min. RMS, both channels driven, at 1 kHz, with no more than AGA ecsevee. bs RcsssstavssastecacteTrasneieccd + 12 dB (8 kHz)
1% total harmonic distortion. 12 watts per channel into 6 DELIGHT BASS
ohms, DELIGHT BASS 1 o..eeececeeeeee +12 dB (40 Hz)
DELIGHT BASS 2.0... .ecccesceeeeees +12 dB (80 Hz)
Load impedance..................:0:0008 6~16 ohms (MASTER VOLUME 30 dB)
-to be continued-

Sansui A-X950 Specifications

General

Power Output	130 watts per channel into 8Ω (stereo)
Frequency Response	5Hz to 100kHz
Signal-to-Noise Ratio	82dB (MM), 105dB (line)
Damping Factor	60
Dimensions	430 x 148 x 368mm
Weight	11.7kg
Input Sensitivity	2.5mV (MM), 150mV (line)
Speaker load impedance	4-16 ohms
Total harmonic distortion	0.005%
Input Impedance	47k ohms
Output	150mV (line)
Channel separation	70dB (1kHz)