Need help?Do you have a question about the Santec LCOS-SLM SLM-200 and is the answer not in the manual?
General| Refresh Rate | 60 Hz |
|---|---|
| Reflectivity | > 60% |
| Frame Rate | 60 Hz |
| Contrast Ratio | 1000:1 |
| Input Signal | HDMI |
| Type | LCOS |
| Resolution | 1920 x 1080 |
| Pixel Pitch | 6.4 μm |
| Active Area | 12.3 mm x 6.9 mm |
| Wavelength Range | 400 nm - 1000 nm |
| Phase Modulation | > 2π radians |
| Power Consumption | 10 W |
Lists the main characteristics and specifications of the SLM.
Provides guidelines for safe operation, environmental conditions, and handling.
Lists optical, electrical, operating, and storage characteristics.
Explains the LCOS display technology and its structure.
Guides on connecting the SLM to a PC and power source.
Details the correct procedure for powering on the SLM and PC.
Outlines PC requirements and steps for installing the SLM software.
Guides on installing the necessary USB device driver.
Details the installation process for the SLM GUI control software.
Introduces the main components of the SLM GUI interface.
Generates CGH (Computer Generated Hologram) phase patterns.
Describes the interface of the CGH generation application.
Outlines the steps for generating CGH from a target BMP image.
Specifies the location of wavefront correction data files on the USB drive.
Provides steps for using the SLM Pattern Generator for correction.
Explains how to use Excel sheets for wavefront correction data.
To Next Page
