Sanyo CM29FS2 - Page 16

Connection Other Equipment
16
16
V
I
D
E
0
R
L
Y
C
B
CR
MONITOR
OUT
S-WOOFER
OUT
AV1 INPUT
AUDIO
AUDIO
S-VIDEO
(MONO)
R
L
(MONO)
AUDIO
S-WOOFER
R
L
VIDEO
AV3 / DVD
INPUT
To Audio Input-R (AV1)
To Audio Input-L (AV1)
To S-VIDEO Input
Video/DVD Player with
S-VIDEO output terminal
■ Input from S-VIDEO terminal is prior to that
from AV1 video terminal. When S-VIDEO
terminal is used, video input from the AV1
terminal will be disabled. When the AV1 input
terminal is to be used, the S-VIDEO terminal
shall be unplugged.
It is convenient to use the AV2 input jack on the
front panel for equipment that is often connected
and disconnected.
Connection of the Front AV2 Input Terminal
Connecting to a DVD Player (Both
Used DVD and AV3)
■ Connecting to a DVD Player with Video
Component Video Output Terminal (Y, C
b or Cr).
1
1 Press the MENU button, then select
“SETTING” with .
Connect the component output terminal on your
DVD player to the component video input terminal
of this product, you will be able to enjoy higher
quality picture than that received when common
video terminal or S-VIDEO terminal is used.
(NOTE: When a signal of Y,Cb,Cr
/Y,Pb,Pr is
received, the output signal from monitor output ter-
minal will not be corresponding.)
■ To watch a program in this connection status,
select DVD.
In this connection status, whenever the
TV/AV button is pressed, the mode will
change as follows:
■ Make sure the component video terminal (Y, Cb
or Cr) is connected correctly.
IMPORTANT!: The AV3 must be set on DVD sta-
tus. To set in DVD status see explanation below.
■ DVD Status Setting.
L - AUDIO - R
VIDEO
TV/AV
MENU
CH
From Camcoder
or video game
equipment
To Audio Input-L (AV2) To Audio Input-R (AV2) To Video Input (AV2)
Camcoder, TV
Game etc.
V
I
D
E
0
R
L
Y
C
B
CR
MONITOR
OUT
S-WOOFER
OUT
AV1 INPUT
AUDIO
AUDIO
S-VIDEO
(MONO)
R
L
(MONO)
AUDIO
S-WOOFER
R
L
VIDEO
AV3 / DVD
INPUT
To Audio Input-R (AV3)
To Audio Input-L (AV3)
To C
R Input Terminal
DVD player with video
component (Y, C
B, CR)
output terminal
To C
B Input Terminal
To Y Input Terminal
28
AV1 AV2
(TV mode)
DVD
-/- -
TV / AV
■ To watch the Front AV2 video input picture,
select AV2 position by pressing the TV/AV
Selector.
Connecting to a DVD Player with
S-VIDEO Terminal
■ When watching a video program input from
the S-VIDEO terminal, press the TV/AV button
to select AV1.
Inst. Manual C8ZRL-A (ME) 12/7/05 3:48 PM Page 16