Sanyo DC-TS760 - Setup Procedures

- 10 -
SERVICE MODE
C. Setup Procedures
1. Displaying SERVICE MODE screen
Display Service Mode screen following the instructions "How to
enter Service Mode" above.
Region 0
Market
WM
BackendVersion
S21225A1
LoaderVersion
55 50 05
Value
2. Displaying Internal Setup screen
Push NEXT button within three seconds after operating the
Service Mode display.
On the Internal Setup screen shown on the right, set up Market
and Region.
Internal Setup
Markett W M
Region 1
Exit
00-WM
01-SFC
02-UK
03-XE
S18
05-SS 06-PA
07-AU 08-CN
09-JP
00
04-
3. Setting Market code
3.1. While a highlighted indicator is displayed on the right side
of the Market denotation, push ENT button on the remote
controller.
With each push the indicator will advance as shown
below.
Internal Setup
Markett W M
Region 1
Exit
00-WM
01-SFC
02-UK
03-XE
S18
05-SS 06-PA
07-AU 08-CN
09-JP
00
04-
3.2. Specify the code of the model in accordance with the
Market/Region Setup Table above.
3.3 Once the desired code is displayed, push p button to
move the highlighted indicator to the Region input area.
Market/Region setup table.
Model Market Region
DC-760/AU AU 4
(Reference figure)