Need help?Do you have a question about the Sanyo DCX 3000K and is the answer not in the manual?
General| Power output | 50W per channel (8 ohms, 20Hz-20kHz, 0.08% THD) |
|---|---|
| Frequency response | 10Hz-50kHz (±1dB) |
| Total harmonic distortion | 0.08% (20Hz-20kHz, 50W) |
| Dimensions | 420 x 150 x 360 mm (W x H x D) |
| Weight | 8.2kg |
| Input sensitivity | 150mV (line), 2.5mV (MM phono) |
Covers basic unit dimensions, weight, power, and general component types like IC, FET, Transistors, and Diodes.
Details radio frequency reception parameters including frequency range, intermediate frequency, and sensitivity.
Defines sound output power, frequency response, bandwidth, signal-to-noise ratio, and input sensitivities.
Procedures and settings for calibrating the AM radio reception.
Steps for tuning and aligning the FM radio reception.
Calibration steps for optimizing stereo FM signal separation.
Lists external packaging, cabinet components, and chassis mechanical parts.
An overview of major electrical components used in the chassis.
Details parts for the RF, IF, and MPX circuit board, including semiconductors, resistors, and capacitors.
Lists additional capacitors for the RF, IF, MPX P.C.B. and provides a bottom view diagram.
Lists components for the pre-amplifier circuit board (PRE-AMP P.C.B.).
Lists components for the pre-microphone and tone control circuit board (PRE. MIC. TONE P.C.B.).
Lists components for the matrix circuit board (MATRIX P.C.B.).
Provides specific resistor values and tolerances for the matrix circuit board.
Lists components for the pilot light control circuit board (PILOT P.C.B.).
Lists components for the front and rear amplifier circuit boards (FRONT REAR AMP P.C.B.).
To Next Page
