1. IN THE SERVICE ADJUSTMENTS LIST (Continued)
PAGE 4
— 2 —
Table 1. ON-SCREEN SERVICE MENU
When IC802 (EEPROM) is replaced, check the bus data to confirm they are the same as below. The shaded menu should be checked
and be set up or readjusted according to the procedures described in the following pages. Initial Setup Data marked with an * should
be changed from Initial Reference Data. (See page 3 for Initial Bus Data Setup.)
No. TITLE
INITIAL REFERENCE INITIAL SETUP
RANGE OF DATA FUNCTION
DATA DATA
001 HP 15 14* 0~31 Horizontal Phase (Horizontal Centering)
002 IAS 0 0 0, 1 IF AGC Switch 0: TV (Normal) 1: AV (IF Gain Minimum)
003 RAD 25 25 0~63 RF AGC Delay
004 PT 64 64 0~127 PLL Tuning
005 ADA 31 31 0~63 APC Detect Adjust
006 CD 0 0 0, 1 C-Diff
007 VS 32 32 0~63 Vertical Size
008 RB 0 0 0~255 Red Bias
009 GB 0 0 0~255 Green Bias
010 BB 0 0 0~255 Blue Bias
011 RD 60 60 0~127 Red Drive
012 BD 60 60 0~127 Blue Drive
013 TDS 0 1* 0, 1 Trap & D (B.P.F.) Switch
0: OFF 1: ON
014 AF 0 1* 0, 1 Auto Flesh 0: OFF 1: ON
015 BS 0 0 0, 1 Black Stretch 1: OFF 0: ON
016 VL 4 4 0~7 Video Level
017 FL 15 15 0~31 FM Level
018 NIS 1 1 0, 1 N/I Switch (Black Noise Inverter) 1: OFF 0: ON
019 ABL 1 1 0,1 ABL Defeat
0: OFF 1: ON
020 WP 1 1 0,1 White Peak Limiter 1: OFF 0: ON
021 GD 7 7 0~15 Green Drive Reduction
022 VC 0 0 0~7 Vert. Comp
023 VD 32 32 0~63 Vert. DC
024 AG 3 0* 0~3 AFC Gain 00: Auto 01: High Gain 10: Low Gain 11: Non-Gate
025 SB 32 32 0~63 Sub-Brightness
026 SCO 10 7* 0~31 Sub-Color
027 STI 14 20* 0~31 Sub-Tint
028 SSH 8 8 0~15 Sub-Sharpness
029 OPT 0 0 0~255 Option 1 (See Note 1 page 5.)
030 OP2 0 0 0~255 Option 2 (See Note 2 page 5.)
031 HR 24 28* 0~63 H-Position (OSD H-Position)
032 INP N/A N/A N/A N/A
033 STE N/A N/A N/A N/A
034 FIL N/A N/A N/A N/A
035 LSP N/A N/A N/A N/A
036 HSP N/A N/A N/A N/A
037 SPV N/A N/A N/A N/A
038 PCO N/A N/A N/A N/A
039 PTI N/A N/A N/A N/A
040 SBO 0 0 0~255 Sub Bright Offset
041 DRV
0~127 Red drive Adjustment (See Note 3 page 5.)
0~127 Blue Drive Adjustment (See Note 3 page 5.)
– 0 0 0~255 Red Bias Adjustment (See Note 4 page 5.)
042 – 0 0 0~255 Green Bias Adjustment (See Note 4 page 5.)
– 0 0 0~255 Blue Bias Adjustment (See Note 4 page 5.)
043 T00 0 0 0~255 N/A
↓↓ ↓ ↓ ↓ ↓
115 T48 0 0 0~255 N/A
To Next Page
Loading...
