— 3 —
NO. TITLE
INITIAL REFERENCE INITIAL SETUP
RANGE OF DATA FUNCTION
DATA DATA
63 R03 0 0 0~255 ROM Data 3
64 R04 0 1* 0~255 ROM Data 4
65 R05 0 0 0~255 ROM Data 5
66 R06 0 0 0~255 ROM Data 6
67 R07 0 0 0~255 ROM Data 7
68 R08 0 169* 0~255 ROM Data 8
69 R09 0 0 0~255 ROM Data 9
70 R10 0 231* 0~255 ROM Data 10
71 R11 0 103* 0~255 ROM Data 11
72 R12 0 3* 0~255 ROM Data 12
73 R13 0 173* 0~255 ROM Data 13
74 R14 0 48* 0~255 ROM Data 14
75 R15 0 1* 0~255 ROM Data 15
76 R16 0 76* 0~255 ROM Data 16
77 R17 0 154* 0~255 ROM Data 17
78 R18 0 231* 0~255 ROM Data 18
79 R19 0 0 0~255 ROM Data 19
↓↓ ↓ ↓ ↓ ↓
131 R71 0 0 0~255 ROM Data 71
132 R72 0 180* 0~255 ROM Data 72
Table 1. ON-SCREEN SERVICE MENU (Continued)
VERTICAL CENTERING ADJUSTMENT
1. Tune receiver to an active channel.
2. Check that picture is in the vertical center of TV screen. If picture center is too low, replace resistor R513 (2.2K ohm, 1/2W) with
470 ohm, 1W. If picture center is too high, connect resistor R512 (470 ohm, 1W).
2. IN THE SERVICE ADJUSTMENTS LIST
PAGE 6
Note: The change in Vertical Centering Adjustment above is also effective in Chassis No. 19500-00.
To Next Page
Loading...
