— 5 —
PROGRAM CODE
The microprossesor used in this model is a multi-purpose
type and is used in several different models. To ensure
proper operation and the correct features for your
particular model, the Program Code must be correct.
Note 3.
Option Data (NO. 83 OPT) should be set to hexadecimal 84.
See page 3 INITIAL DATA SETUP step 14 for set up
procedure. If this program code is wrong the TV will not
operate properly.
Note 4.
Option Data (NO. 84 OP2) should be set to hexadecimal 00.
If this program code is wrong the TV will not operate
properly.
Note 1.
Red/Blue Drive Adjustments in Service Menu NO. 8F DRV:
Adjust Red and Blue Drive Levels alternately with 1, 3, 7,
and 9 keys on the remote control. (See Figure 1.) The Drive
Level adjustment data will be written in the Service Menu
No. 4A RD and 4C BD automatically.
1
2
3
4 5 6
7 98
RB(–)
RB(+)
BB(–)
BB(+)
(N/A)
GB(–)
(N/A)
GB(+)
(N/A)
FOR RED BIAS ADJUSTMENT
FOR BLUE BIAS ADJUSTMENT
FOR GREEN BIAS ADJUSTMENT
Figure 1.
Figure 2.
1
2
3
4 5 6
7 98
RD(–)
RD(+)
BD(–)
BD(+)
(N/A)
(N/A)
(N/A)
(N/A)
(N/A)
FOR RED DRIVE ADJUSTMENT
FOR BLUE DRIVE ADJUSTMENT
Note 2.
Red/Green/Blue Bias Adjustments in Service Menu
NO. 90:
Adjust each Bias Level with 1, 3, 4, 6, 7, or 9 key on the
remote control. (See Figure 2.) The Bias Level adjustment
data will be written in the Service Menu No. 47 RB,
No. 48 GB, and No. 49 BB automatically.
BIT FUNCTION
DATA
01
0, 1 NOT USED – –
2 AV FUNCTION NO AV AV
3 ~ 7 NOT USED
DRIVE AND BIAS ADJUSTMENTS
BIT FUNCTION
DATA
01
0 V–GUIDE YES NO
1 ~ 7 NOT USED – –
8 GAME MODE NO YES
To Next Page
Loading...
