Sanyo DS31590 - BASIC HOOKUP METHODS

— 4 —
Table 1. ON-SCREEN SERVICE MENU
When IC802 (EEPROM) is replaced, check the bus data to confirm they are the same as below. The shaded menu should be
checked and be set up or readjusted according to the procedures described in the following pages. Initial Setup Data marked
with an * should be changed from Initial Reference Data. (See page 3 for Initial Bus Data Setup.)
NO. TITLE
INITIAL REFERENCE INITIAL SETUP
RANGE OF DATA FUNCTION
DATA DATA
01 HP 15 17* 0~20 H-Phase (H-Centering)
02 IAS 0 0 0, 1 IF AGC Switch 0: TV (Normal) 1: AV (IF Gain Minumum)
03 RAD 25 25 0~63 RF AGC Delay
04 PT 64 64 0~127 PLL Tuning
05 ADA 31 31 0~63 APC Detect Adjust
06 CD 0 0 0, 1 C-Diff
07 VS 32 32 0~63 Vertical Size
08 RB 0 0 0~255 Red Bias
09 GB 0 0 0~255 Green Bias
10 BB 0 0 0~255 Blue Bias
11 RD 60 60 0~127 Red Drive
12 BD 60 60 0~127 Blue Drive
13 TDS 0 0 0, 1 Trap & D (B.P.F.) Switch 0: OFF 1: ON
14 AF 0 1* 0, 1 Auto Flesh
0: OFF 1: ON
15 BS 0 0 0, 1 Black Stretch 1: OFF 0: ON
16 VL 4 4 0~7 Video Level
17 FL 15 15 0~31 FM Level
18 NIS 1 1 0, 1 N/I Switch (Black Noise Inverter) 1: OFF 0: ON
19 ABL 1 1 0,1 ABL Defeat 0: OFF 1: ON
20 WP 1 1 0,1 White Peak Limiter
1: OFF 0: ON
21 GD 7 7 0~15 Green Drive Reduction
22 VC 0 0 0~7 Vert. Comp
23 VD 32 32 0~63 Vert. DC
24 AG 3 0* 0~3 AFC Gain 00: Auto 01: High Gain 10: Low Gain 11: Non-Gate
25 SB 32 32 0~63 Sub-Brightness
26 SCO 10 8* 0~31 Sub-Color
27 STI 14 19* 0~31 Sub-Tint
28 SSH 8 8 0~15 Sub-Sharpness
29 OPT 0 36* 0~255 Option 1 (See Note 1 page 5.)
30 OP2 0 72* 0~255 Option 2 (See Note 2 page 5.)
31 HR 43 47* 0~63 H-Position (OSD H-Position)
32 INP 32 32 0~63 Input Level (Composite Input)
33 STE 32 32 0~63 Stereo VCO
34 FIL 63 63 0~63 fH Reject Filter
35 LSP 32 32 0~63 Low Separation
36 HSP 32 32 0~63 Hi Separation
37 SPV 32 32 0~63 SAP VCO
38 PCO 32 32 0~63 PIP Color
39 PTI 32 32 0~63 PIP Tint
40 DRV
55 60* 0~127 Red drive Adjustment (See Note 3 page 5.)
55 60* 0~127 Blue Drive Adjustment (See Note 3 page 5.)
– 0 0 0~255 Red Bias Adjustment (See Note 4 page 5.)
41 – 0 0 0~255 Green Bias Adjustment (See Note 4 page 5.)
– 0 0 0~255 Blue Bias Adjustment (See Note 4 page 5.)