Sanyo ECR-238 - Page 39

3.1 DISASSEMBLY
@ Disassembly is performed using procedures that
are opposite the assembly procedures described
in section 3.2, “ASSEMBLY” .
@ Disassembly printer components beyond the
examples shown in “Exploded View of Model-
405R” at the end of this manual may result in
damage to the printer and its functions, so you
are advised not to do so.
@ The presence in column “Reassembly Step” of
(white star) mark indicates <POINT IN
DISASSEMBLY> in the “Points of Assembly
Work” column, so be sure to refer to such points
during disassembly work.
3.2 ASSEMBLY
@ The assembly process is divided into
subassembly and main assembly. Subassembly
refers to preassembling parts to a certain extent
to form units, and main assembly can be
performed to assemble the units into a printer.
@ The presence in column “Assembly Procedure”
of a *% (black star) mark indicates that
<CHECK> or <ADJUSTMENT> is necessary.
For the <ADJUSTMENT> refer to
“ADJUSTMENTS” .
@ Circled numbers in the “Reassembly Step”
column indicate that lubrication is required
during the reassembly of that component and
that such lubrication will be difficult unless
performed during reassembly.
@ A detailed description of lubrication, including
points requiring lubrication upon completion of
main assembly, is given in section 2.3.3,
“Lubrication Points” . Perform lubrication also
with reference to “Lubrication Points of Model-
405R” at the end of this manual.
@ Small parts are all represented by the symbols.
List of Symbols for Small Parts
Designation Standard
M3X4
S-2 | Cross-recessed head machine screw M3X3
Bind
-3 4 Cross-recessed head tapping screw M3X6
C.P. screw with Plain washer M3X8
Retaining ring Type-E
:
nl w &
@ J aQ
Ps
— 39 —